AT&T AUDIX Networking 585-300-903 - Manual (Page 51)

DCP Mode 1 Networks — 56 Kbps 4-5
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________ _ ______________________________________________________________________________________
AUDIX SYSTEM REQUIREMENTS FOR DCP MODE 1
Each AUDIX system requiring access to a switched 56 network must be running R1V5 or later software.
Each AUDIX system must also be equipped with a TN539 or TN539B ACCE circuit pack, the AUDIX
Networking Breakout cable (H600-331, Group 1 or Group 2). Also, if the RS-232 ports are to be used for
DCP Mode 1 transmission, an MPDM/M1* with an RS-232 interface card is required. If loopback testing
is to be conducted for an R1V5 or R1V6 AUDIX system, an MPDM/M1* with a V.35 interface card is
required. In addition, each AUDIX system must be within 5000 cable feet (1525 meters) of the switch’s
DCP interface.
RS-232
ACCESS
H600-331
GROUP 2
H600-331
GROUP 2
CDR
CROSS-CONNECT
FIELD
CROSS-CONNECT
FIELD
ACCUNET
SWITCHED 56
NETWORK
POINT-OF
PRESENCE
SWITCH
POINT-OF
PRESENCE
SWITCH
RS-232
RS-232
SWITCH
AUDIX
DCP
DCP
SWITCH
AUDIX
H600-330
GROUP 1
Figure 4-2. PC Added to a DCP Network