Document Outline

• FM Stereo FM-AM Receiver
  • About This Manual Table OF CONTENTS
    • Conventions
    • Getting Started
    • Additional Information
    • Index 23
    • Quick Reference Guide Back cover
    • Inserting batteries into the remote
      • Notes
  • Hookup Overview
    • Before you get started
  • Antenna Hookups
    • Overview
      • Important
        • Note
        • 'Q' If you have poor AM reception
        • What antennas will I need?
    • Hookups
      • FM wire antenna
  • Audio Component Hookups
    • Overview
      • White (L) Red(R)
    • Hookups
  • Speaker System Hookups
    • Overview
      • Black cQlt:
    • Hookups
      • Front speakers
      • Rear and center speakers
  • Video Component Hookups
    • Overview
      • What cords will I need?
        • Active woofer
          • Active woofer
        • V* If your TV has separate speakers
    • Hookups
      • TV or Direct Broadcasting Satellite (DBS) tuner
        • TV or DBS tuner
  • AC Hookups
    • Caution
  • Before You Use Your Receiver
  • Selecting a Component
    • 'Q' When you watch TV or video programs
    • Using the remote [X]
      • SYSTEM — STANDBY
      • If you want to change the factory setting of a button
      • If the component does not turn on
        • If you use a Sony TV
        • Watching TV without the receiver (for Sony TVs only)
    • Changing the factory setting of a SYSTEM CONTROL/FUNCTION button
      • To turn off the components
      • To reset the setting to the factory setting
  • Receiving Broadcasts
    • Example 2: AM 1350 kHz
    • To receive other stations
      • 'Q' If you cannot tune in a station and the entered numbers are flashing
      • y To watch FM simulcast TV programs
      • If you enter a frequency not covered by the tuning interval
  • Presetting Radio Stations
    • Receiving broadcasts by scanning stations (automatic tuning)
      • Note
    • Tuning preset stations (preset tuning)
  • Recording
    • Recording on an audio tape or MiniDisc
      • Note
    • Recording on a video tape
      • 'Q* You can replace the audio while recording on a video tape
  • Selecting a Surround Mode
    • Q' You can find Dolby Surround-encoded software by looking at the packaging
    • Adjusting the effect level (C.STUDIO and HALL mode only)
      • Note
  • Getting the Most out of Dolby Pro Logic Surround Sound
    • Selecting the center mode
    • Adjusting the speaker volume
      • Q' You can adjust all the speakers at one time
      • 'Q' You can increase the output range of the rear speakers
    • Adjusting the delay time
  • Troubleshooting
    • There's no sound or only a very low-level sound is heard.
    • The left and right sounds are unbalanced or reversed.
    • Severe hum or noise is heard.
    • Radio stations cannot be tuned in.
    • Surround effect cannot be obtained.
    • No picture or an unclear picture appears on the TV
    • screen.
    • The remote does not function.
    • No sound is heard from the center speaker.
    • No sound or only a very low-level sound is heard from the rear speakers.
    • Recording cannot be made.
  • Specifications
    • AUDIO POWER SPECIFICATIONS
    • Amplifier section
      • POWER OUTPUT
      • Frequency response
      • Inputs
    • Sensitivity Impedance S/N
    • (weighting network, input level)
    • FM tuner section
      • Antenna terminals
      • Usable sensitivity
      • Harmonic distortion at 1 kHz
      • Frequency response
    • AM tuner section
      • Usable sensitivity
      • Harmonic distortion
    • General
      • Power requirements
      • Power consumption
      • Mass (Approx.)
      • Supplied accessories
  • Glossary
    • Center mode
    • • NORMAL mode
    • WIDE mode
      • Front Front
      • Rear
    • PHANTOM mode
      • Rear
    • 3 CH LOGIC mode
      • Front Front
    • Delay time
    • Direct tuning
    • Dolby Pro Logic Surround
    • 5.1 INPUT
    • Preset station
    • Surround sound
    • Types of sound
    • In a system without a center speaker (PHANTOM mode)
    • • Transition of sound from rear speakers
    • Test tone
    • • In a system with a center speaker (N0RMALWIDE/3CH LOGIC modes)
      • 3CH LOGIC
  • Rear Panel Descriptions
  • Remote Button Descriptions
    • E, F,G
    • H, I, J, K, u M, N, O
    • U, V, W, X, Y, Z
    • P,Q
  • Receiving Broadcasts
  • Scanning Radio Stations
  • Selecting a Component
  • Using Pre-programmed Surround Modes
  • Receiving Preset Stations