Document Outline

• DMT152 USER'S GUIDE
  • TABLE OF CONTENTS
  • GENERAL INFORMATION
    • About This Manual
      • Contents of This Manual
      • Version Information
      • Related Manuals
      • Documentation Conventions
    • Safety
      • ESD Protection
    • Recycling
    • Regulatory Compliances
    • Trademarks
    • Warranty
  • PRODUCT OVERVIEW
    • Introduction to Dewpoint Transmitter DMT152
    • Basic Features and Options
    • Transmitter Structure
  • FUNCTIONAL DESCRIPTION
    • Advanced DRYCAP® Technology
      • Auto-Calibration
      • Sensor Purge
  • INSTALLATION
    • Selecting the Location
    • Installing the Transmitter
    • Wiring
      • Connection Cables
      • Power Supply Requirements
    • Sampling from a Process
      • Pressure
      • Leak Tightness and Materials
      • Flow
    • Sampling Accessories
      • DMT242SC Sampling Cell
      • DMT242SC2 Sampling Cell with Swagelok Connectors
      • DSC74 Sampling Cell with Quick Connector and Leak Screw
      • DSC74B Two Pressure Sampling Cell
        • DSC74C Two-Pressure Sampling Cell with Coil
    • NW40 Mounting Flange
  • SERIAL LINE OPERATION
    • Serial Communication
      • Connecting to the Serial Interface
        • Installing the Driver for the USB Cable
      • Terminal Application Settings
    • List of Serial Commands
    • Device Information and Status
      • Show Device Information
      • Show Transmitter Status
      • Show Firmware Version
    • Configuring Analog Outputs
      • Limit Alarm
      • Purge Status Alarm
      • Malfunction Alarm
      • Select Analog Output Quantity and Scaling
    • Configuring Serial Line Operation
      • Set Serial Line Settings
      • Set Serial Line Response Time
      • Set Transmitter Address
      • Format the Measurement Output
      • Select Unit
      • Set Serial Interface Mode
    • Configuring Measurement Parameters
      • Enable or Disable Sensor Purge
      • Set Pressure Value for ppm Calculation
      • Set Molar Mass for ppmw Calculation
    • Serial Line Output Commands
      • Start Measurement Output
      • Stop Measurement Output
      • Set Output Interval
      • Output a Reading Once
    • Troubleshooting and Maintenance Commands
      • Display the Currently Active Errors
      • Test Analog Outputs
      • Calibrate Analog Output
      • Extend Analog Output Range
    • Other Commands
      • Opening the Transmitter in POLL Mode
      • Closing the Connection to a Transmitter in POLL Mode
      • Display Command List
      • Set Time
      • Reset Transmitter
      • Set LED Voltage
      • Restore Factory Settings
  • MAINTENANCE
    • Cleaning the Transmitter
    • Changing the Filter
    • Calibration and Adjustment
      • Field Check Using DM70
  • TROUBLESHOOTING
    • Typical Problems
    • Unknown Serial Settings
    • Error State
    • Error Codes
    • Technical Support
    • Product Returns
  • TECHNICAL DATA
    • Measured Variables
    • Operating Environment
    • Outputs
    • General
    • Output Cable Specifications
    • Spare Parts and Accessories
    • Dimensions in mm (inches)