Document Outline

• Front Cover
  • Safety Information
  • Technical Assistance
  • Your Feedback
• Table of Contents
• Chapter One - Overview
  • Introduction
  • Setup Steps
• Chapter Two - Installation
  • Installing the Series 97 Controller
  • Removing the Series 97 Controller
• Chapter Three Wiring
  • Wiring the Series 97
    • Input-to-output Isolation
  • Wiring Example
  • Wiring Notes
  • Input 1 Wiring
    • Thermocouple
    • RTD (2- or 3-Wire) 100Platinum
  • Input 2 Wiring
    • Digital Event
  • Output 1 Limit Output Wiring
    • AC Outputs
  • Output 2 Alarm Output Wiring
    • AC Outputs
    • Switched DC, Open Collector
  • Output 3 Alarm Wiring
    • AC Outputs
  • Output 4 Wiring
    • AC Outputs
    • Communications and Retransmit Option
  • EIA-232 to EIA-485 Conversion
  • Termination for EIA-232 to EIA-485 Converter
• Chapter Four - Navigation and Software
  • Keys and Displays
  • Navigating the Series 97
    • Navigation
    • Software Map
    • Setup Page
    • Factory Page
    • Basic navigation for new users
• Chapter Five - Features
  • Limit
  • Input
    • Calibration Offset
    • Filter Time Constant
    • Sensor Selection
    • Range Low and Range High
    • Event Input
    • Retransmit
  • Alarms
    • Alarms An leaves whether Alarm Set Points alarm high set point defines the temperature that will trigger a high side alarm. The high set point must be higher than the alarm low set point and lower than the high of the sensor range. alarm low set point defi
    • Alarm Hysteresis
    • Process
    • Alarm Latching
    • Alarm Silencing
  • Communications
    • Overview
• Chapter - Six Parameters
  • Parameter Setup Order
  • Home Page
  • Operations Page
    • Monitor Menu
    • Limit Menu
    • Alarm Menu
  • Setup Page
    • Input 1 Menu
    • Input 2 Menu
    • Output 1 Menu
    • Output 2 Menu
    • Output 3 Menu
    • Output 4 Menu
    • Display Menu
    • Global Menu
  • Factory Page
    • Lockout Menu
    • Diagnostics Menu
    • Input Calibration Menu
    • Output Calibration Menu
• Appendix
  • Troubleshooting Alarms and Errors
  • Modbus Remote Terminal Unit (RTU)
    • Writing a Modbus Application
    • Packet Syntax
    • Read Multiple Registers Command
    • Loop Back Command
    • Exception Responses
    • Cyclical Redundancy Checksum (CRC) Algorithm
  • Modbus Register Numbers
  • Calibrating the Series 97
    • Thermocouple Input Procedure
    • RTD Input Procedure
    • Process Output Procedures
  • Glossary
  • Specifications
  • Ordering Information
  • Index
  • Prompt Index
  • Declaration of Conformity
  • Software Map
  • How to Reach Us
  • Warranty
  • Returns