Hitachi VT-FX631A-VT - Manual (Page 17)

17
goes out for more than 1 hour. When you first plug in the VCR or after a power outage,
the clock display will read "--:--".
Methods for setting the clock installed with these VCR's
For VT-FX632A, use method A or B.
For VT-FX631A, use method B.
A Automatic mode See pages 17~19.
The following is the method for setting the clock with auto clock set function.
Auto clock set function
This function sets the VCR's clock automatically when the VCR is tuned to a
station which transmits a time signal together with TV programs.
It also automatically sets the time differences between various time zones and sets
the time during Daylight Saving Time (D.S.T). The auto clock set function
operates each time the VCR is turned off.
• Some broadcast stations may not transmit a time signal. The auto clock set
function does not operate
when the VCR is tuned to a station which does not transmit a time signal. In
this case, set the clock
manually (See page 20).
• When the clock is set automatically, the displayed time may drift from the
current time by up to one
minute.
B Manual mode See pages 20~21
With this method, input the time and date following the clock setting screen.
Automatic Mode (VT-FX632A only)
Setting the clock automatically
If your VCR's hooked up to an antenna or cable without a without a cable box
(Hookups A, B, C or D)
1 Press the POWER button to turn the VCR power off.
If the VCR is already turned off, press the POWER button to turn the power on, then
press it
again to turn the power off. The time will appear in the VCR display to show that the
current
time has been set. The automatic clock set procedure might take about 5 minutes.