Hitachi VT-FX631A-VT - Manual (Page 39)

39
Remote Control Illustration.
VIEWING THE ON-SCREEN DISPLAY
•
Switching between the clock, time counter and time of
remaining tape
Press DISP while the on-screen display is displayed. The on-screen display switches in the order below together
with the VCR's display.
Press the DISP button to see the clock.
Remote Control Illustration.
Press the DISP button a second time to see just the time counter.
On-screen Display Illustration
Notes:
• The linear time counter operates only if there is something recorded on the tape.
• The counter changes to 0:00:00 when the tape is ejected.
Press the DISP button a third time to see the tape remaining time.
On-screen Display Illustration
Note: Immediately after the tape is inserted, "
-:--
" will appear. 2 minutes after playback or recording is
started, the tape remaining time is displayed.
Press the CLEAR button repeatedly to switch the type of tape is used. The correct remaining time
will appear.
AUTO: T-120 or shorter tape
T-160: T-140 or T-160 tape
T-180: T-180 tape
T-210: T-210 tape
Notes:
• The tape remaining time is not displayed correctly for a tape without any recordings or tapes other than
T-30/60/90/120/140/160/180/210.
• The remaining time may not be displayed correctly during fast forwarding or rewinding.
INDEXING WITH THE TIME COUNTER
•
To find specific sections on a tape
Indexing with the Time Counter
You can set the time counter to memorize a certain point in the video programming, and you can return to that
point automatically.