Hitachi VT-FX631A-VT - Manual (Page 56)

56
play) or EP (extended
play).
The screen will display all the details of the program you chose. Check the
CH number to make sure it is
the right one.
If not, you need to check your VCR Plus+ channel setup again.
• If you have installed a cable box (see page 26), the cable box output
channel will appear in the Ch
column
7 Review the screen to be sure everything is set as you want, then press
the PROGRAM button
to complete your programming or continue with additional programs.
8 Press the POWER button to turn off the VCR.
The delayed recording indicator will display on the VCR.
This tells you that the VCR will automatically record at the times and dates you have programmed.
Note: If a cassette has not been inserted or a cassette without safety tab has been inserted, the delayed
recording indictor will flash to warn you. The cassette without safety tab will be ejected automatically. Be sure to
insert a cassette with safety tab intact.
When you have set up all the timed recordings you want:
• Don't forget to load a videocassette (With the safety tab still attached) to record on.
• If you have installed a cable box (see page 26), turn on the cable box and select the channel you want to
record on the cable box before recording starts.
Important: Your timed recording settings take effect when you turn off the power on the VCR.
Caution of VCR Plus+ Recording
After entering a PlusCode number, check the information displayed with the "PROGRAM REVIEW". If there is
(are) any unnecessary program(s), please cancel or correct it (them). Please refer to Page 53, "Reviewing what
you have programmed".