HP 2600/2700 - Manual (Page 38)

5 Load originals and load paper
This chapter provides instructions for loading originals on the glass to copy, scan, or
fax; choosing the best paper type for your job; loading paper in the input tray; and
avoiding paper jams.
Load an original
You can copy, scan, or fax up to letter- or A4-size originals by loading them on the
glass, as described here. You should also follow these instructions when loading a
proof sheet on the glass for photo printing.
Note Many of the special features will not work correctly if the glass and lid backing
are not clean. For more information, see
Clean the HP all-in-one .
To load an original on the glass
1 Lift the lid and place your original face down on the right front corner of the glass.
If you are loading a proof sheet, make sure the top of the proof sheet is lined up
against the right edge of the glass.
Tip For more help on loading an original, refer to the guides along the front and
right edges of the glass.
2 Close the lid.
Tip You can copy or scan oversized originals by completely removing the lid from
your HP all-in-one. To remove the lid, lift the lid to the open position, grasp the
sides of the lid, and then pull the lid upward. Your HP all-in-one functions
normally with the lid removed. Replace the lid by inserting the tabs on the
hinge back into the appropriate slots.
User Guide 35
Load
originals
and load paper