Heat & Glo Fireplace WS-250 - Manual (Page 17)

17
Part #831-1700
The blower is shipped fully assembled and
ready for installation.
1. Using three 1/4-20 bolts supplied, attach
blower to lower rear of stove, as shown.
2. Plug blower cord into a grounded outlet.
Do not remove ground prong from plug.
Route power cord to avoid heat from the
stove, or other damage.
3. Adjust the blower speed control to the
desired speed.
BLOWER SWITCH ADJUSTMENTS
The blower speed control for this unit is ad-
justed at the factory, and should not require
further adjustment. When the speed control
is turned clockwise, it will click on to high
FIGURE 21
3. Medium burn setting: The blower should be left
off until a good burn is established, then turned
on at a medium or high rate.
4. Low burn setting: The blower tends to cool off
the stove. If you are using wet wood or a very low
burn setting, leave blower off until the burn is well
established. Then, if you wish, turn the blower on
at a lower rate. Too high a blower setting with a
low burn rate may adversely affect emissions.
5. The blower is equipped with a speed control. The
highest blower speed is obtained by turning the
speed control on and then adjusting back towards
off as far as possible without turning the blower
off. For a low blower speed, turn the control knob
clockwise as far as possible.
speed. Turn the speed control clockwise to decrease
the speed. At full clockwise, the blower should blow
gently, but should not stop.
STEPS FOR ADJUSTING THE BLOWER
SPEED CONTROL
1. With the unit plugged in, turn the speed control
knob to slow (full clockwise).
2. With a small screwdriver, adjust the blower
speed by turning the adjustment mechanism
through the hole on the side of the speed control.
3. Adjust the speed so the blower runs slowly, but
does not stop. Turn clockwise to slow the blower
and counterclockwise to increase the speed.
BLOWER OPERATING INSTRUCTIONS
If your wood stove is equipped with an optional blower,
you should follow these guidelines:
1. Initial (cold) start-up: Leave blower off until your
stove is hot and a good coalbed is established.
The blower may be turned on approximately 30
minutes after loading the stove with fuel.
2. High burn setting: The blower may be left on
throughout the burn.
INSTALLATION OF OPTIONAL BLOWER