HP 2600 - Manual (Page 182)

Port Status and Basic Configuration
Viewing Port Status and Configuring Port Parameters
Per-Port MDI
Configuration
Figure 10-2. Example of Displaying the Current MDI Configuration
Per-Port MDI
Operating Mode
Figure 10-3. Example of Displaying the Current MDI Operating Mode
N o t e Port Response to Switch Software Updates
■ Series 2600 or 2600-PWR Switch software updated from H_07.XX or
earlier
■ Series 2800 Switch software updated from I_07.XX or earlier
1. Copper ports in auto-negotiation still default to auto-mdix mode.
2. Copper ports in forced speed/duplex default to mdix mode.
The default is
auto-mdix. If the switch is reset to the factory defaults, these ports
are configured as
auto-mdix. Use the following CLI command to change the
setting for individual ports:
interface < port-list > mdix-mode < automdix | mdi | mdix >
10-16