HP 2600 - Manual (Page 273)

Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
[no] snmpv3 targetaddress < addr-name > params < parms-name>
< IP-Addr > ( — Continued — )
max-msg-size<size>
The maximum number of bytes of length a message to
this target can be. ( Default:1472)
taglist < tag-params >
Set list of values used to select this entry from
snmpNotifyTable.
[no] snmpv3 params < params-name > user < user-name >
Add or delete a user parameter for use with target
address. The params-name must match the
parms-name
in the targetaddress command. The user-name should be
a User from the user table. For more information on
users see “SNMP Version 3 Users” on page 13-8
A complete params command must also have a sec-model
and msg-processing entry.
< sec-model < ver1 | ver2c | ver3 >>
This established the security model to use for messages
passed to the targetaddress. IF ver3 is used then the
msg-processing must also be ver3.
< msg-processing < ver1 | ver2c | ver3> [noaut | auth | priv >
Establish the msg-processing for algorithm for
messages passed to the target address. If
ver3 is used
and sec-model is ver3 then you must select a security
services level (< noauth | auth | priv >)
tagvalue matches taglist value.
params value matches
params name.
Both ver3 means you must select a
security service level.
Figure 13-8. Example of SNMPv3 Configuration Session
13-19