HP 2600 User Manual
Page 395
Troubleshooting
Restoring a Flash Image
4. Since the OS file is large, you can increase the speed of the download by
changing the switch console and terminal emulator baud rates to a high
speed. For example:
a. Change the switch baud rate to 115,200 Bps.
=> sp 115200
b. Change the terminal emulator baud rate to match the switch speed:
i.
In HyperTerminal, select
Call | Disconnect.
ii. Select
File | Properties.
iii. Click on
Configure . . ..
iv. Change the baud rate to
115200.
v.
Click on
[OK]
. In the next window, click on
[OK]
again.
vi. Select
Call | Connect
vii. Press
[Enter]
one or more times to display the => prompt.
5. Start the Console Download utility by typing
do at the => prompt and
pressing
[Enter]
:
=> do
6. You will then see this prompt:
7. At the above prompt:
a. Type
y
(for Yes)
b. Select
Transfer | File in HyperTerminal.
c. Enter the appropriate filename and path for the OS image.
d. Select the
Xmodem protocol (and not the 1k Xmodem protocol).
e. Click on
[Send]
.
If you are using HyperTerminal, you will see a screen similar to the
following to indicate that the download is in progress:
C-45