Heat & Glo Fireplace ST-38HV-AU - Manual (Page 2)

2
IMPORTANT: Read all instructions carefully before starting installation.
Failure to follow these installation instructions may result in a possible fire
hazard and will void the warranty. Save this manual for future reference.
Heat & Glo, a brand of Hearth & Home Technologies, Inc.
20802 Kensington Blvd., Lakeville, MN 55044, USA
MODEL ST-38HV-AU
IS AUSTRALIAN GAS ASSOCIATION
APPROVED FOR NATURAL GAS OR
PROPANE AS A BALANCED FLUE
HEATER.
Refer to the appliance data plates for gas
consumptions and pressures.
Installation of this appliance should only be
carried out by an authorized person in accor-
dance with the manufacturers instructions. All
relevant codes and regulations laid down by
the gas fitting authorities, municipal building
regulations, electrical wiring regulations, and
the requirements of the AGA Gas Installation
Code must be observed.
This appliance and its components are tested
and safe when installed in accordance with
this Installation Manual. Report to your dealer
any parts damaged in shipment, specifically
check glass condition. Read all instructions
before starting installation and follow these in-
structions carefully during installation to ensure
maximum benefit and safety. Failure to follow
them will void your warranty and may present
a fire hazard.
The Heat & Glo warranty will be voided by, and
Heat & Glo disclaims any responsibility for the
following actions:
• Installation of any damaged heater or flue
system component
• Modification of the heater or balanced flue
system installation other than as instructed
by Heat & Glo.
• Improper positioning of the gas logs or the
glass door
• Installation and/or use of any component
part not manufactured or approved by Heat
& Glo , not withstanding any independent
testing laboratory or other party approval
of such component part or accessory.
INSTALLATION AND OPERATION INSTRUCTIONS
PLEASE READ THIS MANUAL BEFORE INSTALLING AND
USING THIS APPLIANCE.
Copyright 2005 • Printed in U.S.A.
Heat & Glo
Quality Systems
registered by SGS ICS