Husqvarna 850 - Manual (Page 14)

12
– English
E
PRESENTATION
Lift lever for cutting unit
The lift lever is used to set the cutting unit in trans-
port or cutting position.
If the lever is pulled back the unit will lift up and the
blades stop rotating (transport position).
If the lock button is pressed and the lever is moved
forward the unit will lower down and the blades
begin rotating (cutting position).
The lever can also be used to temporarily regulate
the cutting height, e.g. for a small mound in the
lawn.
Lifting of the cutting unit (transport position)
Lowering of the cutting unit (cutting position)
Lever for adjustment of cutting height
With this lever the cutting height can be adjusted to
9 different positions (40–90 mm, 45–80 mm
Bioclip).
850,970 Eng 97-10-14, 14.29 12