Honeywell DOLPHIN 6500 - Manual (Page 12)

2 - 2
5. Replace the hand strap.
We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may result in damage not
covered by the warranty.
Step 2. Charge the Batteries
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-
Honeywell peripherals, cables, or power adapters may cause damage not covered by the warranty.
DO NOT attempt to charge damp/wet mobile computers or batteries. All components must be dry
before connecting to an external power source
.
!
Dolphin 6500s ship with both the main battery pack
and internal backup battery significantly
discharged of power. Charge the main battery
pack with the Dolphin charging cable until the LED
turns green (red while charging). The average
charge time for a fully depleted main battery is
5 1/2 hours. It takes less time if the battery has
some charge.
1.
Attach the appropriate plug adapter to the
plug of the power cable.*
2. Insert the plug into the appropriate power
source.
3. Plug the Dolphin power cable into the DC
Power Jack (see page 3-11) on the bottom
end of the unit.
Note: If you remove the battery pack or it completely
discharges, there is a 30 minute window in which
to insert a charged battery pack before the
backup battery completely discharges. If your
backup battery completely discharges, the
contents of the RAM memory will be lost. If your
backup battery is less than fully charged, there is
a proportionally smaller window of time available.
LED Indicators
Red LED On Charging
Green LED On Battery is fully charged
1
2
3
!