Honeywell DOLPHIN 6500 - Manual (Page 24)

3 - 8
Back Panel Features
Hand Strap
The Dolphin 6500 comes with an adjustable, elastic hand strap. The strap is attached to the
device with the two small screws. It is threaded through the slot on the bottom of the back of
the unit.
Keep in mind that the hand strap covers the battery. When you want to replace the battery, you
will need to adjust the hand strap accordingly.
Rear Scan Button
The Dolphin 6500 has a Scan button conveniently located on the back of the unit. This button
works like the SCAN button located on the front of the unit. Pressing this button can also
resume a suspended device.
Finger Saddle
This is a slightly depressed and angled area of the back housing that is designed to cradle or
“saddle” your finger while holding the terminal. This unique ergonomic design makes the
terminal comfortable to hold and helps prevent you from accidentally dropping the terminal.
Installed Battery
For information about installing the battery, see Changing the Main Battery Pack on page 3-13.
For information about battery power, see Battery Power on page 3-12.
Speaker
The integrated speaker sounds audio signals as you scan bar code labels and enter data, but
emits no ambient noise on system activity (i.e., processor, memory access, radio traffic, etc.).
The speaker can also be used for playing sounds (e.g., WAV or MP3 files).
The speaker meets the following SPL levels at 40cm:
• 500Hz–67db
• 1KHz–72db
Image Engine Window
Speaker
Installed Battery
Finger
Saddle
Hand Strap (with Stylus)
Rear Scan Button