Fuji Bikes FRENIC 5000G11S/P11S - Manual (Page 24)

2-12
The switching connectors are mounted on the power PCB
above the control PCB as shown on the right.
Note:
To remove a connector, unlock the connector (using the
locking mechanism) and pull. To mount a connector, push
the connector until it click locks.
FRN040G11S-4UX to FRN150G11S-4UX
FRN200G11S-4UX to FRN350G11S-4UX
When shipped from the factory, CN UX is connected to the U1 side
and CN RXTX is connected to the L1/R-L3/T side.
Factory shipment status Connector removal After connector switching.
CNUX : U1
CNRXTX : L1/R-L3/T
In this figure the power voltage is 380 to 398V AC, 50Hz (or 380 to
430V AC, 60Hz) and the inverter is used in DC power input mode.
Fig. 2-3-11 Power switching connectors (only for 40HP or more)
<Enlarged view of part A>
<Oblique view of part A>