Fluke DSP-2000 - Manual (Page 104)

DSP-100/2000
Users Manual
5-4
• Selected Autotest Reports: Displays the SELECT
AUTOTEST REPORTS screen where you can select the reports you want to
print, as follows:
1. Use
#Page Up, $Page Down, and/or D U to highlight a
report label.
2. Press
E to select the highlighted report. An asterisk appears on the
label to show that the report is selected for printing. To select several
consecutive reports, hold down
E. To remove an asterisk,
highlight the report label; then press
E.
3. To print the selected reports, press
! Start Print. To stop
printing and return to the main Print menu, press
e.
• All Report Summary: Same as All Autotest Reports, except that
reports are printed in summary form. The summaries give the date and time
each report was saved, the cable identification entered for each report, and an
overall test result for each report.
• Selected Report Summary: Same as Selected Autotest Reports,
except that reports are printed in summary form.
• Edit Report Identification: Displays the REPORT
IDENTIFICATION screen, where you can edit the Custom Header, Operator
Name, or Site Name, as follows:
1. Turn the rotary switch to PRINT.
2. Use
D to highlight Edit Report Identification; then
press
E.
3. Use
D U to highlight the information you want to edit; then press
E.
If you are editing an operator or site name, you can press
@ New to
add a new name. The
New softkey appears only if less than 20 names
have been entered.
To rename or delete an existing operator or site name, press
! Edit,
select the desired name; then press
! Rename or @ Delete.
Changes to names preceeded by a "$" appear on printed test reports. You
cannot delete a name that is used on a saved report.