Fluke DSP-2000 - Manual (Page 100)

DSP-100/2000
Users Manual
4-24
Using the Tone Generator (Model DSP-2000)
If you have an inductive pickup device, you can use the test tool’s tone generator
to identify cable runs and connections. The tone generator produces a signal on
the cable under test. You can hear the signal as an audible tone when you place an
inductive pickup device near the cable or one of the cable’s connectors.
To use the tone generator, proceed as follows:
1. Turn the rotary switch to SPECIAL FUNCTIONS.
2. Use a patch cable of the correct impedance to connect the test tool to the
CABLE TEST jack.
3. Use
D to highlight Tone Generator; then press E.
4. Use an inductive pickup device along the cable run or at far end connectors to
determine which cable is connected to the test tool.