Fluke DSP-2000 - Manual (Page 160)

DSP-100/2000
Users Manual
A-2
Installing DSP-LINK
The DSP-LINK installation program copies the DSP-LINK files from the diskette
provided to the drive of your choice. The program creates a \DSPLINK directory
for storing the files. The installation program also allows you to change the name
and path of this directory.
To install DSP-LINK on your computer, proceed as follows:
1. Put the DSP-LINK diskette in either the A: or B: floppy disk drive.
2. From Windows, use the Program Manager or the File Manager to run the file
SETUP.EXE from the DSP-LINK diskette.
3. Follow the instructions given by the SETUP program.
Preparing for Data Transfer
For all data transfer operations, you must connect the test tool to the PC with the
appropriate interface cable and set the test tool’s and PC’s serial ports to the same
configuration.
Connecting to a PC
To connect the test tool to a PC, use the 9-pin serial interface cable provided with
the test tool. Refer to Figure A-1. If your PC has a 25-pin serial port, you can use a
Fluke 25-pin adapter, Fluke P/N 929187.
To verify the pin assignments for a different 25-pin adapter or a different cable,
refer to the pin assignments for the serial interface cable given in “Specifications”
in Chapter 8.