Fluke DSP-2000 - Manual (Page 34)

DSP-100/2000
Users Manual
2-18
The following tests apply to coaxial cable:
•
Impedance: Measures the impedance of the cable.
•
Resistance: Measures the loop resistance of the cable, shield, and terminator.
•
Length: Measures the length of unterminated cables.
•
Anomaly Detection: During a coaxial cable test, the test tool also detects and
reports the position of the largest impedance anomaly (if any are present) on
the cable.
Single Test
The SINGLE TEST mode provides access to the individual tests defined by the
selected test standard, except for the ACR test. This mode also allows execution
of TDR and TDX

analyzer tests. A scanning function, which continuously
repeats the test, is available for the wire map, resistance, TDR, and TDX analyzer
tests.
Monitor
The MONITOR mode allows you to continuously monitor impulse noise on
network cables or network activity on Ethernet systems. Network activity is
monitored for collisions, jabber, and percentage of system utilization.
The MONITOR mode also includes a hub port locator, which helps you determine
port connections at a hub. Model DSP-2000 includes a hub port capabilities
feature that determines the standards supported by a port.