Fluke DSP-2000 - Manual (Page 37)

Getting Started
Turning On the Test Tool
2
2-21
Selecting a Language for Displays and Reports
The test tool displays results and prints reports in English, German, French,
Spanish, and Italian.
To select a language for displays and reports, proceed as follows:
1. Turn the rotary switch to SETUP.
2. Press
$Page Down four times.
3. Use
D to highlight the currently selected language.
4. Press
! Choice.
5. Use
D U to highlight the language you want.
6. Press
E to accept the highlighted language. The test tool’s display now
appears in the selected language.
Performing a Self-Test
The self-test verifies that the test tool and the remote are operating properly. To
run the self-test, proceed as follows:
1. Turn the rotary switch to SPECIAL FUNCTIONS.
2. Use
D to highlight Self Test.
3. Press
E.
4. Use the 2m Cat5 patch cable provided to connect the test tool to the remote as
described on the display.
5. Press
T to start the self-test.
6. When the self-test is complete, you can either return to the main Special
Functions menu by pressing
e or start a new operation by turning the
rotary switch to a new position.
If the self-test fails, refer to “If the Test Tool Fails” in Chapter 8.