Fluke DSP-2000 - Manual (Page 44)

DSP-100/2000
Users Manual
2-28
Setting the Power-Down Timer
To extend battery life, you can set the power-down timer to automatically switch
the test tool to a low-power mode after a selected period of inactivity. You can
also disable the power-down timer.
When the test tool switches to low-power mode, the display goes blank. To
reactivate the display, press
C.
To set the power-down timer or enable/disable the timer, proceed as follows:
1. Turn the rotary switch to SETUP.
2. Press
$Page Down once.
3. Use
D to highlight the power-down timer status.
4. Press
! Choice.
5. Use
D U to highlight the desired time-out period or the enable/disable
status.
6. Press
E to accept your selection.
Model DSP-2000 turns itself off if not used for 30 minutes after power-down.
When this happens, pressing
C turns on the test tool. The test tool then goes
through its power-on sequence as though it were turned on with the rotary switch.
Enabling or Disabling the Audible Tones
To enable or disable the test tool’s audible tones, proceed as follows:
1. Turn the rotary switch to SETUP.
2. Press
$Page Down twice.
3. Use
D to highlight the audible tone status.
4. Press
! Choice.
5. Use
D U to highlight the desired enable or disable status.
6. Press
E to accept your selection.