Fluke DSP-2000 - Manual (Page 50)

DSP-100/2000
Users Manual
3-2
Autotest on Twisted Pair Cable
The procedures for an Autotest on shielded and unshielded twisted pair cable are
the same. When shielded cable is selected, the test tool performs an additional test
for shield continuity if the shield test is enabled in SETUP.
To run the Autotest on twisted pair cable, refer to Figure 3-1 and proceed as
follows:
RJ45
Jack
Wall Outlet
Patch Panel
2 Meters
Test Tool
2 Meters
ENTER
TEST
FAULT INFO
EXIT
SAVE
1 2 3 4
OFF
PRINT
MONITOR
SETUP
SPECIAL
FUNCTIONS
SMART
REMOTE
SINGLE TEST
AUTO
TEST
WAKE UP
DSP-2000 CABLE ANALYZER
Smart
Remote
OFF
ON
DSP-2000SR SMART REMOTE
PASS
TESTING
FAIL
LOW BATTERY
gc08f.eps
Figure 3-1. Autotest Connections for Twisted Pair Cable (Basic Link Configuration and DSP-
2000 Shown)