Fluke DSP-2000 - Manual (Page 73)

Autotest
The Autotest Report
3
3-25
Automatically Incrementing the Cable Identification Name
The test tool’s auto increment function increments the last alphanumeric character
of the cable identification name each time you save Autotest results.
To enable or disable the auto increment function, proceed as follows:
1. Turn the rotary switch to SETUP.
2. Press
$ Page Down once.
3. Press
! Choice.
4. Use
D U to highlight the status you want.
5. Press
E to select the highlighted status.
If Memory is Full
If the Autotest results you save fill the last available memory location, the
following message appears:
WARNING! TEST RESULT MEMORY IS NOW FULL. If you try to
save additional test results after the memory has been filled, the following
message appears:
UNABLE TO SAVE TEST RESULTS. MEMORY IS FULL.
To save additional test results, you must first delete one or more test reports from
memory. You can delete test reports in the SPECIAL FUNCTIONS mode. For
complete instructions, see Chapter 5, “Viewing and Printing Saved Reports.”
You can see how many memory spaces are available by pressing the
$Memory softkey, which appears on several Autotest displays.
Note
The test tool can store the results from more than 500 Autotests. The
exact number of memory spaces available depends on the number of
tests run by the selected test standard.
The Autotest Report
Figures 3-9, 3-10, and 3-11 on the following pages show how Autotest results
appear in printed reports. You can print Autotest reports or edit the report’s
identification information in the PRINT mode. See Chapter 5, “Viewing and
Printing Saved Reports,” for complete instructions.