Fluke DSP-2000 - Manual (Page 80)

DSP-100/2000
Users Manual
4-4
Running a Single Test on Twisted Pair Cable
To run a test as a Single Test, refer to Figure 4-1 and proceed as follows:
RJ45
Jack
Wall Outlet
Patch Panel
2 Meters
Test Tool
2 Meters
ENTER
TEST
FAULT INFO
EXIT
SAVE
1 2 3 4
OFF
PRINT
MONITOR
SETUP
SPECIAL
FUNCTIONS
SMART
REMOTE
SINGLE TEST
AUTO
TEST
WAKE UP
DSP-2000 CABLE ANALYZER
Smart
Remote
OFF
ON
DSP-2000SR SMART REMOTE
PASS
TESTING
FAIL
LOW BATTERY
gc19f.eps
Figure 4-1. Single Test Connections for Twisted Pair Cable (Model DSP-2000 Shown)
Note
For instructions on running the TDR test or TDX analyzer, or
running tests from the MONITOR mode, see the later sections on
those topics in this chapter.
Note
The standard remote does not support remote end testing.