Furuno GP-7000F - Manual (Page 22)

16
5. Using the vertical adjustment space on the bracket slots, slide the sensor up or down to pro-
vide a projection of 3 mm (1/8"). Tighten the screws.
Vertical adjustment and cable routing
Attaching the sensor to the bracket
1. If the retaining cover near the top of the bracket is closed, open it by depressing the latch and
rotating the cover downward.
Attaching the sensor to the bracket
2. Insert the sensor's pivot arms into the slots near the top of the bracket.
3. Maintain pressure until the pivot arms click into place.
4. Rotate the sensor downward until the bottom snaps into the bracket.
5. Close the retaining cover to prevent the accidental release of the sensor when the boat is
underway.
Cable routing
Route the sensor cable over the transom, through a drain hole, or through a new hole drilled in
the transom above the waterline.
Never cut the cable or remote the connector; this will void the warranty. Always wear safety gog-
gles and a dust mask.
1. If a hole must be drilled, choose a location well above the waterline. Check for obstructions
such as trim tabs, pumps, or wiring inside the hull. Mark the location with a pencil. Drill a hole
through the transom using a 19 mm or 3/4" bit (to accommodate the connector).
2. Route the cable over or through the transom.
3. On the outside of the hull secure the cable against the transom using the cable clamps. Posi-
tion a cable clamp 50 mm (2") above the bracket and mark the mounting hole with a pencil.
Cable cover
Cable
clamp
50 mm (2")
Hull projection 3 mm (1/8")
Step 1
Step 4
Step 3
Step 2
Latch
Retaining
cover
Pivot
arm (2)
Slot (2)