Furuno GP-7000F - Manual (Page 36)

30
3.3 Echo Sounder Settings
Setting transducer model, output power
The GP-7000F is preset to use a 600 W transducer (520-5PSD, 525-5PWD, 520-5MSD). For a 1
kW transducer, follow the procedure below. Note that the optional Distributor MB-1000 and cable
assy. 02S4089 are necessary in order to use a 1 kW transducer.
1. Use the [DISP] key to choose an echo sounder display.
2. Press the [MENU] key to show the menu bar.
3. Rotate the [ENTER] knob to choose SOUNDER from the menu bar and then push the
[ENTER] knob.
ECHO SOUNDER SYSTEM SETUP menu
4. Rotate the [ENTER] knob to choose SOUNDER SETUP and then push the [ENTER] knob.
SOUNDER SETUP menu
5. Rotate the [ENTER] knob to choose TRANSDUCER and then push the [ENTER] knob.
6. Rotate the [ENTER] knob to choose 1KW and then push the [ENTER] knob.
7. Press the [MENU] key to close all open windows and erase the menu bar.
Output Power Transducer
600 W 520-5PSD, 525-5PWD, 520-5MSD
1 kW 50B-6, 50B-6G, 200B-5, 200B-5S, 50/200-IT
AUTO MODE PRESET FISH
DISPLAY MODE NORMAL
FREQUENCY 50 KHz
PICTURE ADVANCE 1/1
TEMPERATURE GRAPH On
ZOOM MARKER On
A-SCOPE Off
SOUNDER SETUP
SENSOR SETUP
TRANSMISSION On
TRANSMISSION POWER High
TRANSDUCER 600W
50 KHz TVG 00
200 KHz TVG 00
50 KHz ECHO OFFSET +000
200 KHz ECHO OFFSET +000
50 KHz BOTTOM LEVEL +000
200 KHz BOTTOM LEVEL +000
SMOOTHING SM2
DEPTH INFORMATION Large
PLAYBACK SOUNDER IMAGE
Off
ECHO SOUNDER SIMULATION Off
600W
1KW