FORD Ranger - Manual (Page 80)

Instrument Panel Controls
79
* [IP03100(R )10/95] Temperature selection
[IP03150(R )03/95] The temperature control knob is the rotating knob located at the
center of the control with tapered red and blue bands
surrounding most of the knob. The wide red part of the band
(full right) is the heat or warmer area. The wide blue area (full
left) is the cool or unheated temperature area. Any position
selected between full right and full left will give a temperature
between the two extreme temperatures. The cool temperature
you select will not be cooler than the outside temperature.
* [IP03200(R )03/95] H Fan speed adjustment
[IP03250(R )03/95] The H (left) knob on the control is the fan control knob which
controls the volume of airflow. Rotate the H knob to the right
to increase fan speed and increase the amount of air entering
the vehicle. Four fan speed positons are available and are
indicated by dots beside the
H control knob. The largest dot is
high speed position.
* [IP03300(R )08/94] Airflow selections
[IP03350(R )08/95]
Q (Panel)
[IP03400(R )03/95] Use Q to bring outside air through the instrument panel
registers. You can heat the air in this position by rotating the
temperature knob into the RED area. The air cannot be cooled
below the outside temperature regardless of the temperature
knob setting.
[IP03450(R )03/95]
S (Panel & Floor)
[IP03500(R )03/95] Select S to get airflow to the floor and through the instrument
panel registers at the same time. This selection can be used to
either heat or ventilate your vehicle.
* [IP03550(R )08/95]
R (Floor)
[IP03600(R )03/95] Select R to direct air to the floor. The air cannot be cooled in
the
R position but can be heated by rotating the temperature
knob into the red area.
File:06unipr.ex
Update:Wed May 1 13:46:22 1996