Fluke ESA612 - Manual (Page 25)

Electrical Safety Analyzer
Setting Up the Analyzer
11
Setting Up the Analyzer
There are a number of Analyzer parameters that are
adjusted through a setup function as well as the ability to
save a record by ID and date. To access the first Setup
menu shown in Figure 6, press Q.
fis114.bmp
Figure 6. Setup Menu
Note
See the Using Memory section later in this
manual for a description of how to enter a test
record ID.
The setup parameters have been grouped into six
categories: Instrument, Display, Sound, Instrument Info,
Calibration, and Diagnostics.
Setting Polarity Switching Delay
When switching the polarity of the Analyzer’s test
receptacle, a delay can be set to control the actual switch
time. To set the polarity delay:
1. From the setup menu, press the softkey labeled
More to reveal additional menu selections.
2. Press the softkey labeled Instrument to reveal the
instrument setup selections.
3. Press the softkey labeled Polarity Delay to open the
scroll box above the softkey label.
4. Press G or H to adjust the delay from 0 to 5
seconds in 1 second steps.
5. Press the softkey labeled Done to exit the switching
polarity delay setup function.
Setting the Display Contrast
There are two methods for setting the display contrast.
From the Select a Test…. menu or through the setup
menu.
Whenever the Analyzer displays its start-up menu (Select
a test…), pressing G or H will increase or decrease the
display’s contrast respectively. Press the softkey labeled
Done to exit contrast setup.
Another way to adjust the contrast is through the
Analyzer’s setup menu.