FUJITSU LIFEBOOK B142 - Manual (Page 59)

Four
U s e r I n s t a l l a b l e F e a t u r e s
L i f e B o o k B S e r i e s f r o m F u j i t s u
49
To Install the Port Replicator:
The Port Replicator can be installed on your
notebook while the power is on, while in
Suspend mode, or while the power is off.
1. Open the Docking Connector cover on the
rear panel of your notebook to expose the
Docking Connector.
2. Align the Docking Connector on the rear
panel of your notebook with the Docking
Connector on the front panel of the Port
Replicator. (Figure 4-3.)
3. Push the Port Replicator and the notebook
together until the docking connectors are
fully engaged. (Figure 4-3.)
4. Turn the Port Replicator Attachment Knobs
clockwise to secure the connection between
the Port Replicator and the notebook. You
may have to push the knob in slightly to
engage the threads. (Figure 4-4.)
Figure 4-2 Port Replicator Rear Panel
Port Replicator
Attachment Knob
PS/2 Port
External Floppy
Disk Drive Port
Serial Port
Parallel Port
External
Monitor Port
Port Replicator
Attachment Knob
Figure 4-3 Connecting the Port Replicator
Docking Connector
Docking Connector
Figure 4-4 Securing the Connection
Port Replicator
Attachment Knob
Port Replicator
Attachment Knob
Figure 4-5 Releasing the Connection
Port Replicator
Attachment Knob
Port Replicator
Attachment Knob
Figure 4-6 Removing the Port Replicator
Docking Connector
Docking Connector