FUJITSU LIFEBOOK B142 - Manual (Page 65)

Four
U s e r I n s t a l l a b l e F e a t u r e s
L i f e B o o k B S e r i e s f r o m F u j i t s u
55
4. Remove the screws of the memory upgrade
compartment. (Figure 4-10.)
5. Remove the cover by lifting it by the notch in
the right edge and pulling it to your right.
6. Remove the memory upgrade module from
its static guarded sleeve.
Figure 4-10 Memory Upgrade Installation
C A U T I O N
Never remove screws except the ones
specifically shown in the directions for
installing and removing the memory
upgrade module.
P O I N T
For further information about memory
modules for upgrades please visit our
web site at www.fujitsu-pc.com.
To Install a Memory Upgrade Module
1. Turn off power to your notebook using the
power switch, (see Power Off on page 16),
and remove any power adapter (AC or
auto/airline.)
2. Make sure that all the connector covers
are closed.
3. Turn the notebook bottom side up, with the
front panel toward you.
C A U T I O N
Memory upgrade modules can be
severely damaged by electro-static
discharge (ESD). Be sure you are
properly grounded when handling
and installing the module.
7. Align the connector edge of the memory
upgrade module with the connector slot in
the compartment. The notch on the module
should be on the right with the part side up,
the connector pointing towards the back of
the notebook and aligned with the notch in
the connector inside the compartment.
(Figure 4-10.)
8. Insert the memory upgrade module at a
45° angle. (Figure 4-10.) Press the con-nector
edge of the module firmly down and into
the connector.