Furuno GP-30/35 - Manual (Page 15)

1-8
9. Press ▲ or ▼ to display 6.
10.Press s to send the cursor to the next
digit.
11. Press ▲ or ▼ to display 3.
12.Press s to send the cursor to the last
digit.
13.Press ▲ or ▼ to display 0.
14.Press the [ENT] key.
15.Press the [MENU] key twice to finish.
1.7 Simulator Display
The simulator display provides simulated
operation of this unit. You may set the speed
manually and the course manually or auto-
matically. All controls are operative – you
may enter marks, set destination, etc.
1. Press the [MENU] key twice to display
the MAIN MENU.
2. Select SYS SETUP and press the [ENT]
key.
SYSTEM SETUP
11–DEC–97 14: 20: 25
DATUM : WGS84
UNITS : nm, kt
TIME DIFF : +00 : 00
SELF TEST?
SIMULATOR?
Figure 1-14 SYSTEM SETUP menu
3. Select SIMULATOR? and press the
[ENT] key.
SIMULATOR
11–DEC–97 14: 20: 25
MODE : OFF
SPEED : 20 kt
COURSE : AUTO
LAT : 38
°
00'N
LON : 123
°
00'W
Figure 1-15 SIMULATOR menu
4. Press the [ENT] key.
5. Select ON and press the [ENT] key.
6. Press the [ENT] key, enter speed to use
for the simulation with the Cursor Pad,
and press the [ENT] key.
7. Press the [ENT] key.
8. Select course entry method (AUTO or
MANU) and press the [ENT] key. For
manual entry of course, press the [ENT]
key again, enter course with the Cursor
Pad, and press the [ENT] key again. (The
AUTO course tracks a circular course.)
9. Press the [ENT] key, enter latitude (usu-
ally current latitude) with the Cursor Pad,
and press the [ENT] key.
10.Press the [ENT] key, enter longitude
(usually current longitude), and press the
[ENT] key.
11. Press the [MENU] key twice.
12.Select the PLOTTER display with the
[DISP] key. SIM appears at the upper
left-hand corner when the simulator dis-
play is active.
SIM
[ 40 ]
n
m
CSE:
82
°
SPD:
9.0
k
t
34
°
44.000N 135
°
21.000E
Course traced
in AUTO course
Figure 1-16 Simulator display,
auto course selected
13.To turn off the simulator display, select
OFF on the MODE line of the SIMU-
LATOR menu, press the [ENT] key, and
press the [MENU] key twice to finish.
Note: If the power is reset while the simu-
lator display is in use, the indication SIMU-
LATION MODE appears in addition to the
indication SIM.