Meridian Audio D-ILA 1080MF2 - Manual (Page 10)

10
7
[OPERATE] Indicator
Light on: When this unit is in operation (during projec-
tion). ( ☞ Page 20)
8
[OPERATE] Button
When this unit is in the standby mode, pressing this but-
ton for more than 1 second will turn this unit on and cause
the [OPERATE] indicator to light up.
Press it for 1 second or more again to switch the unit to
the cool down mode, which will automatically switch to
the standby mode after about 90 seconds. (
☞ Page 20)
● The [OPERATE] button will not work within approxi-
mately 1 minute after the light source has been turned
on. Start operation only after 1 minute’s time.
9
[EXIT] Button
Press this button to return to the previous hierarchical
menu (for example, to return from submenu to main
menu). Pressing this button when the menu is displayed
will clear the menu. (
☞ Pages 23, 24)
p
[ENTER] Button
Press this button to show the next hierarchical menu (for
example, to enter submenu from main menu). It is also
used when “ENTER” is displayed against a selection item
on the menu screen. (
☞ Pages 23, 24)
q
[HIDE] Button
Use this button to temporarily clear the video image. Press
again to resume. (
☞ Page 21)
Control Panel
LAMP TEMP
STAND BY
OPERATE
6
7
8
9
p
q
3
4
1
2
5
PRESET
MENU EXIT
ENTER
HIDE
1
[TEMP] Indicator
Blinking : Indicates that temperature inside this unit is ab-
normally high. ( ☞ Pages 11, 33)
2
[LAMP] Indicator
Light on: Indicates that lamp has been used for more
than 1900 hours. ( ☞ Pages 11, 28)
Blinking : Indicates that lamp usage time (about 2000
hours) is exceeded. Replace the lamp.
(
☞ Pages 11, 28, 33)
3
[MENU] Button
Press this button to display the menu. Pressing this but-
ton when the menu is displayed clears the menu.
(
☞ Pages 23, 24)
4
Cursor [
5/∞/2/3] Buttons
Use these buttons when adjusting the menu items.
(
☞ Pages 23, 24)
5
[PRESET] Button
Use this button to reset the values to factory settings when
the “Gamma”, “Color temp.”, “Mask” or “Picture shift” item
in the menu is selected.
6
[STAND BY] Indicator
Light on: When in the standby mode. ( ☞ Page 11)
Blinking : When in the cool down mode. ( ☞ Page 11)
Controls and Features (continued)