Fusion TYPHOON L50B PRO - Manual (Page 14)

12
INPUT BATTERY
VOLTAGE ERROR
Error mEssAgEs
NO BATTERY
OUTPUT BATTERY
REVERSE POLARITY
OUTPUT CIRCUIT
PROBLEM
CHECK THE BATT.
OPEN CIRCUIT
CHECK THE BATT.
OVER VOLTAGE
CHECK THE BATT.
LOW VOLTAGE
BALANCER VOLTAGE
IS TOO HIGH
BALANCER VOLTAGE
IS TOO LOW
DON’T CHARGE LiXX
WITH THIS MODE
Input voltage is below 11.0V or exceeds 15V.
Battery is not connected to the charger’s output banana
sockets.
Battery is connected to the output banana sockets in
reverse.
The circuit of the charger has a problem.
Battery has become disconnected during an operation.
Wrong voltage is set while charging Lithium or Pb batteries.
Wrong voltage is set, or batteries are over discharged, while
charging Lithium or Pb batteries.
Voltage per cell is too high during balancing. The pack may
be faulty.
Battery cells are short-circuited during balancing. The pack
may be faulty.
If the charger attempts to start charging with settings for
NiCd/MH, or Pb batteries while there is a balancing cable
connected to the balancing port of the charger. This helps
prevent charging Lithium batteries in the wrong charge
mode.