Fusion TYPHOON L50B PRO - Manual (Page 7)

5
Input powEr
12V DC
Connect the charger’s red alligator clip to the positive (+) terminal on the
power source and the black alligator clip to the negative (-) terminal. The
charger will display “Input voltage” error message if the input is below 11V
or above 15V. If this happens, please recheck the input power supply to
make sure correct power is present.
Output BAttEry ConnEctions
Two 4mm banana sockets are located on the right side of the charger.
Connect the battery main power leads to these sockets with the positive
(+) lead connected to the red socket and the negative (-) lead to the
black socket. You may need to purchase an adaptor lead to suit the
specific connector on you battery and make this more convenient. The “No
battery” error message will be displayed if trying to start charging without
connecting a battery to these sockets. The “Open Circuit” error message
will be displayed if a battery becomes disconnected from the charger
while a function is in progress. A “Reverse Polarity” error message will be
displayed if a battery is connected to the charger in reverse.
Note: In order to balance Lithium batteries during charge, please ensure
that both the battery main power leads and the balancing connector from
the battery pack are connected to both 4mm output banana sockets and
balancing port respectively. The balancing port (JST EH type) requires a
short lead (supplied) and an adaptor board to suit other battery balance
connectors. Two types are supplied to suit Polyquest, Flight Power and
Thunder Power batteries (TP). Other types are available as options.
If the main battery power leads ONLY are connected to the output banana
sockets, without connecting the balancing connector to the balancing port
on the charger, the charger will charge or discharge the connected Lithium
pack without balancing it.