Furuno GP-3500F User Manual
Page 97
7. NAVIGATION
7-3
Navigating to a single quick waypoint
1. Referring to page 7-1 for the procedure, set GO TO METHOD to
“1. 1POINT”.
2. Press the [DISP] key, and then select the PLOTTER NAV INFO 1 or PILOT
NAV INFO 1 display.
3. Press the [DISP] key to close the DISP MODE display.
If the cursor is not displayed, press the [CURSOR ON/OFF] key to display it.
4. Operate the trackball to place the cursor on the location where you want to
enter the quick point.
5. Press the [GOTO] key.
A light-blue line connects between own ship and destination, marked “QP<01>,”
and it shows the shortest course to the destination.
Arrows on the line show the direction to follow to get to the quick point. Range
and bearing from own ship to the destination appear at the top of screen. This
location is saved to the WAYPOINT LIST as waypoint “QP01.”
Note 1: Each time a quick point is entered previous quick points having the
same numbers as newly entered ones are written over.
Note 2: If range and bearing from own ship to the destination do not appear on
the screen, refer to paragraph 9.6.2.
Note 3: When waypoint data (L/L) is received from an external navigator, the
quick waypoint is erased and the waypoint data becomes the new
destination.