FUJITSU C150-E049-02EN - Manual (Page 166)

M3099GX/GH OEM Manual 4-9
BASIC
OPERATION
Loading
Document This section provides how to load documents.
When the LCD display on the operator panel has displayed “Hopper
Empty”, supply documents as follows:
Line mark
Lock
lever
Guide
Document
Hopper table Extension
Hopper table
1 Set the specified document
width.
Hold the lock lever at the
guide center on the right of
the hopper table and move
it horizontal to set the
document width.
2 Load a document read side
face-up on the hopper table.
Note:
1. Be sure not to load
documents higher than the
line marked inside the guide
on each side of the hopper
table.
2. If the documents are too
long, pull out the extension
at the front of the hopper.