FUJITSU C150-E049-02EN - Manual (Page 211)

M3099GX/GH OEM Manual A-6
5 Reset the print head life counter by the
procedure stated in section A2.5. (See
NOTICE)
You can test the printing by the procedure
in section A2.6
NOTICE: The reset of the print head life counter is important to
correctly detect the life of the new print head.
A3.2 Print head position adjustment
You can adjust the print position in mainscanning direction
manually. The position you can set is limited as stated in section 1.
1 Open and remove the endorser cover at
the rear top corner of the scanner. Power
of the scanner will turn off, if the power
is on at the cover open.
2 Pinch the tab near the print head and
slide it to the position you want to print.
The print position is indicated by the
indicater behind the tab and the label
attached on the rear cover.
3 Close the endorser cover.
You can test the printing by the procedure
in section A2.6.
Endorser cover
or
Tab
Slide direction