FRIGIDAIRE 316902300 - Manual (Page 11)

11
Fig. 1 Fig. 2
Cooktop element power level display windows
The cooktop element power level display features provide a
digital display for each of the heating positions located on
the cooktop. Power levels are easily controlled and
monitored using the window displays in combination with
the corresponding control touch pads.
The Triple radiant heating element (some models) has 3
cooking sizes to select from. This feature allows you to
match the size of the element to the size of the cookware
you are using.
Available power level settings
The cooktop control will display heat levels ranging from Hi
(Fig. 1) to Lo (Fig. 6) and OFF (Fig. 7).
The settings between 9.5 (Fig. 2) and 3.0 (Fig. 3) decrease
or increase in increments of .5 (1/2). The settings between
2.8 (Figs. 4) and 1.2 (Fig. 5) are Simmer settings which
decrease or increase in increments of .2 to Lo (Fig. 6) for
more precise settings at lower heat levels.
Use the “Suggested power level settings table”
provided later in this section to determine the correct
setting for the type of food you are preparing.
Hot surface window message (HE)
After using any radiant element the cooktop will be very
hot. After turning any of these elements OFF, the cooktop
will remain HOT for some time. The corresponding HE
(hot element-Fig. 8) message will remain ON and turn
OFF once that element position on the cooktop has cooled
sufficiently (Fig. 7).
Sabbath Day feature (Sb) message
The display windows will show the Sb message whenever
the Sabbath Day feature is active (Fig. 10). When
activated, the Sabbath Day feature works for both the
oven and cooktop together.
Once the Sabbath Day feature is active, changes to the
heat levels for the cooktop elements will not show in the
displays. The cooktop will react slower to heat level
changes. See “Setting the Sabbath Day feature” for
complete instructions.
Fig. 3 Fig. 4
Fig. 5 Fig. 6
Fig. 7 Fig. 8
Fig. 9 Fig. 10
Lockout window message ( - - )
The (- -) message will appear whenever the lockout
feature is active (See Fig. 9). Refer to the lockout
instructions for complete lockout instructions.
BEFORE SETTING SURFACE CONTROLS
When setting the size for all 3 bridge elements to heat
together, both the display windows for the left front and
left rear elements will display the set power level & hot
element message (for models with a bridge surface
element feature only).
NOTE