Grizzly G0555 - Manual (Page 15)

G0555 14" Ultimate Bandsaw -13-
To assemble the stand:
1. Lay one of the stand sides on its back and
secure the two lower braces with (4) M6-1.0
x 16 hex bolts, (4) 6mm flat washers, and (4)
M6-1.0 flange nuts from the hardware bag.
2. Attach the two upper braces to the stand
side in the same manner with (4) M6-1.0 x 16
hex bolts, (4) 6mm flat washers, and (4) M6-
1.0 flange nuts from the hardware bag. Your
assembly should now look like
Figure 7 .
Assembling Stand
Figure 7. Braces attached to stand side.
Figure 8. Second stand side attached
to assembly.
Figure 9. Foot installed into stand corner.
3. Attach the second stand side to the assem-
bly with (8) M6-0.8 x 16 hex bolts, (8) 6mm
flat washers, and (8) M6-0.8 flange nuts from
the hardware bag. Your assembly should
now look like
Figure 8 .
4. Thread a 3 ⁄
8
"-16 hex nut onto each foot and
follow it with a 10mm flat washer.
5. Install the feet into the corner brace of the
stand, and secure it with another
3 ⁄
8
"-16 hex
nut and 10mm flat washer as shown in
Figure 9 .
6. Adjust the feet so that they are approximate-
ly the same height.
This step will make level-
ing the stand easier.
Some metal parts may
have sharp edges that
can cause minor injury.
Please examine the
edges of all metal parts
BEFORE handling them
and be careful WHILE
handling them.