Grizzly G0555 - Manual (Page 21)

G0555 14" Ultimate Bandsaw -19-
Once the assembly is complete and you have
performed the “Blade Tracking” instructions, you
need to test run the machine to continue with the
remainder of the adjustments.
If, during the test run, you cannot easily locate the
source of an unusual noise or vibration, feel free
to contact our service department for help.
To test run the machine:
1. Make sure that you have performed the
“Blade Tracking” instructions before continu-
ing with these instructions.
2. Make sure that the blade guides are moved
away from the blade and that the blade is not
touching the table or table insert.
3. Plug the machine into the power source.
4. Press the ON button. Make sure that your
hand stays poised over the switch in case
you need to quickly turn the machine OFF.
5. Listen to and watch the bandsaw for abnor-
mal noises or actions. The bandsaw should
run smoothly with little or no vibration or rub-
bing noises.
Strange or unnatural noises
should be investigated and corrected before
operating the machine further—always
unplug the machine when investigating or
correcting any situation with the machine.
Test Run
Blade Centered
on Peak of Crown
Blade
Centered
on Wheel
CENTER TRACKING
Figure 19. Center tracking profiles.
6. Loosen the lock nut on the tracking control
knob threads so that the tracking control
knob will rotate for adjustments.
NOTICE
Changes in the blade tension may change
the blade tracking.
7. Spin the upper wheel with one hand and
rotate the tracking control knob with the other
hand to make the blade ride in the center of
the bandsaw wheel tire.
8. Tighten the tracking control lock nut and
close the upper wheel cover.
For the best performance from your saw, regular-
ly maintain the proper tracking of the blade.
Wear safety glasses dur-
ing the entire test run
process. Failure to com-
ply may result in serious
personal injury.