Notice – Grizzly G0555 User Manual
Page 23
G0555 14" Ultimate Bandsaw
-21-
6.
Tighten the assembly lock bolt.
7.
Loosen the thumbscrew on the support bear-
ing adjustment shaft.
8.
Use the knurled knob to position the support
bearing approximately .016" away from the
back of the blade as illustrated in
Figure 22
.
Figure 23.
Dollar bill folded twice to make a
quick .016" gauge.
5.
Look at the face of the support bearing and
rotate the blade guide assembly side-to-side,
until the blade is perpendicular with the face
of the support bearing as illustrated in
Figure
21
.
Figure 21.
Blade should be perpendicular (90˚)
to the face of the support bearing.
.016''
Figure 22.
Blade should be aligned approxi-
mately .016" away from the bearing edge.
9.
For a quick gauge, fold a dollar bill in half
twice (four thicknesses of a dollar bill is
approximately .016") and place it between
the support bearing and the blade as shown
in
Figure 23
.
10.
Tighten the thumbscrew to keep the support
bearing locked in place.
NOTICE
Whenever changing a blade or adjusting ten-
sion and tracking, the upper and lower blade
support bearings and guide-blocks must be
properly adjusted before cutting operations.
Bandsaw
Blade
Support
Bearing