Grizzly G0458 - Manual (Page 14)

-12-
Model G0458 (Mfg. Since 5/11)
inventory
box 1: (figures 3 & 4) Qty
a. drum Sander .............................................. 1
b. dust Bag ..................................................... 1
c. dust hose Clamp ....................................... 1
d. dust port .................................................... 1
e. Stand legs ................................................. 4
f. Bottom long Brackets ................................ 2
g. top long Brackets ..................................... 2
h. Bottom Short Brackets ............................... 2
i. top Short Brackets ..................................... 2
figure 3. Box Contents.
A
figure 4. Additional box contents.
B
C
d
E
F
i
h
g
J. hardware and tools (not Shown)
— handwheel ............................................ 1
— handwheel handle m10-1.5 ................... 1
— phillips head Screw m6-1 x 25 .............. 1
— Flat Washer 5mm .................................. 1
— hex Bolt m8-1.25 x 20 ........................... 4
— hex nut m8-1.25 ................................... 4
— Flat Washer 8mm .................................. 8
— Carriage Bolt m8-1.25 x 15 .................. 24
— Serrated Flange nut m8-1.25 .............. 24
— Combination Wrench 8/12mm ............... 1
— hex Wrenches 4, 5, 6mm ................ 1 ea
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.