Grizzly G0458 - Manual (Page 19)

Model G0458 (Mfg. Since 5/11)
-17-
dust collection
you may attach the model g0458 drum sander
to a dust collection system if you do not use the
included dust bag. if you are using your own dust
collection system, we recommend using a system
that can collect a minimum of 400 CFm
at the
dust port.
note: Do not confuse this CFM recommendation
with the rating of the dust collector. To determine
the CFM at the dust port, you must take into
account many variables, including the rating of
the dust collector, the length of hose between the
dust collector and the machine, the amount of
branches or wyes, and the amount of other open
lines throughout the system.
When the dust collection is working properly, a
fine layer of dust may be present on your stock
as it comes out of the sander. this is a normal
characteristic of all drum sanders.
to connect the dust ports to a dust collector:
1. Attach a 2 1 ⁄
2
" dust collection hose to the dust
port and secure with a hose clamp.
do not operate the model g0458 without
adequate dust collection. this sander cre-
ates substantial amounts of wood dust while
operating. failure to use dust collection can
result in short and long-term respiratory ill-
ness.
18. Slide the dust port over the fan housing and
tighten the included phillips head screw
(
figure 16).
19. Slide the dust hose clamp over the dust
bag, insert the bag and clamp over the dust
port (
figure 17), and secure with the clamp
handle. do not overtighten the clamping
adjustment or it may break!
figure 16. installing dust port.
dust port
Fan housing
figure 17. installing dust bag and clamp.
dust Bag
Clamp
dust port