Grizzly G0458 - Manual (Page 20)

-18-
Model G0458 (Mfg. Since 5/11)
test run
now that the machine is assembled, perform a
test run to make sure all the controls are working
properly.
to test run the sander:
1. put on safety glasses and make sure any
bystanders are out of the way and also wear-
ing safety glasses.
2. Connect the sander to power.
3. Flip the on/oFF switch ON. make sure that
your finger is poised over the on/oFF switch,
just in case there is a problem.
the drum sander should run smoothly, with
little or no vibration or rubbing noises. Strange
or unnatural noises mUSt be investigated
and corrected before operating the machine
further. to avoid injury or damage to the
machine,
do not attempt to make adjust-
ments to the machine without turning it Off
and unplugging it from its power source.
investigate and correct any problems before
operating the machine further. if you need help,
refer to the
troubleshooting section in the back
of this manual or contact tech Support at (570)
546-9663.
recommended
adjustments
For your convenience, the adjustments listed
below have been performed at the factory and
no further setup is required to operate your
machine.
however, because of the many variables involved
with shipping, some of these adjustments may
need to be repeated to ensure optimum results.
Keep this in mind as you start to use your new
drum sander.
step-by-step instructions for these adjust-
ments can be found in section 7: service
adJustments.
1. V-Belt tensioning (page 27). perform after
the first 16 hours.
2. Feed Belt tensioning & tracking (pages 31
& 32).
3. table Adjustments (page 34).
before starting the sander, make sure you
have performed the preceding assembly
and adjustment instructions, and you have
read through the rest of the manual and
are familiar with the various functions and
safety issues associated with this machine.
failure to follow this warning could result in
serious personal injury!