GE 164D3333P185-1 User Manual

Page 11

Advertising
background image

11

Safety Instructions

Operating Instructions

Care and Cleaning

Installation Instructions

Troubleshooting T

ips

Customer Service

Oven Control

Your oven is controlled by an OVEN TEMP knob. It
will normally take 30-90 seconds before the
flame comes on.

After the oven reaches the selected

temperature, the oven burner cycles—off

completely, then on with a full flame—to

maintain the selected temperature.

Air Adjustment

An air adjustment shutter for the oven burner
regulates the flow of air to the flame.

You’ll find the shutter against the back

wall behind the broiler drawer. To reach

it remove the oven bottom (see the Care
and cleaning of the range

section) and the

burner baffle.

To adjust the flow of air,

loosen the Phillips

head screw and rotate the shutter to allow

more or less air into the burner tube as

needed.

When the right amount of air flows into
the burner,

the flame should be steady,

with approximately 1/2 inch blue cones,

and should not extend out over the

baffle edges.

Loosen

Air
adjustment
shutter

Oven Shelves

The shelves are designed with stop-locks

so when placed correctly on the shelf

supports, they will stop before coming

completely out of the oven and will not

tilt when you are removing food from

them or placing food on them.
When placing cookware on a shelf,

pull the shelf out to the bump on the

shelf support. Place the cookware on the

shelf, then slide the shelf back into the

oven. This will eliminate reaching into

the hot oven.
To remove the shelves from the oven,

pull

them toward you, tilt front end upward

and pull them out.

To replace,

place shelf on shelf support

with stop-locks (curved extension of

shelf) facing up and toward back of oven.

Tilt up front and push shelf toward back

of oven until it goes past the bump on the

shelf support. Then lower front of shelf

and push it all the way back.

Bump

Advertising