GE 15339430 - Manual (Page 11)

7
I
NSTALLATION
IMPORTANT: It is imperative you follow these steps in sequence for proper
installation of the phone. Telephone line cords must be connected before AC
power connection is made. The phone may not install properly, otherwise.
Also, without AC power or the battery installed, pulse dialing and the flash
function will not operate.
Battery
compartment
door
1. Carefully turn over the phone. On the
bottom is the battery compartment door.
Remove the screw on the door with a
screwdriver and open the door.
2. Install a 9V battery, paying close attention
to the battery polarity. Close the battery
compartment door, and tighten the screw
back in place. Carefully turn the phone over
again.
1. Connect an end of one of the long
telephone line cords to the jack on
the back of the phone labeled LINE
1,2. Connect the other end to the
wall jack(s) labeled 1 & 2. There are
two possibilities for this connection.
• One 2-line RJ14 wall jack.
Connect the other end of the line
cord to the wall jack.
OR
1
NOTE: The backup battery is important because should you experience a
power outage, you will still be able to use the phone.
D
ESKTOP
I
NSTALLATION