GE Coil Top - Manual (Page 34)

34
Operating
Instructions
Safety Instructions
Care and Cleaning
Installation Instructions
Troubleshooting T
ips
Consumer Support
Final Check
Be sure all range controls are in the OFF position
before leaving the range.
Anti-Tip Device Installation
An Anti-Tip bracket is supplied with instructions
for installation in a variety of locations. The
instructions include all necessary information
to complete the installation. Read the Safety
Instructions
and the instructions that fit your
situation before beginning installation.
WARNING
■ Range must be secured by Anti-Tip bracket
supplied.
■ See instructions to install (supplied with
bracket).
■ Unless properly installed, the range could
be tipped by stepping or sitting on the door.
Injury might result from spilled hot liquids or
from the range itself.
Leveling the Range
A. Install the oven shelves in the oven and position
the range where it will be installed.
B. Check for levelness by placing a spirit level or
a cup, partially filled with water, on one of the
oven shelves. If using a spirit level, take two
readings—with the level placed diagonally first
in one direction and then the other.
C. Remove the storage drawer, broiler drawer or
kick panel. The front leveling legs can be
adjusted from the bottom and the rear legs
can be adjusted from the top or the bottom.
D. Use an open-end or adjustable wrench to adjust
the leveling legs until the range is level.
Typical installation of anti-tip bracket attachment to wall.
Bracket
Screw must
enter wood
or metal
Wall plate
Read these instructions completely and carefully.
Installation Instructions.
Leg
leveler
Lower
range
Raise
range
(on some models)
(on some models)
Lower
range
Raise
range