GE 15381860 - Manual (Page 7)

7
I
NSTALLATION
& S
ETUP
I
MPORTANT
I
NSTALLATION
I
NFORMATION
• Never install telephone wiring during a lightning storm.
• Never touch uninsulated telephone wires or terminals,
unless the telephone line has been disconnected at the
network interface.
• Use caution when installing or modifying telephone
lines.
I
NSTALLING THE
B
ATTERIES
Your Caller ID phone uses 4 AA-size alkaline batteries for
receiving and storing Caller ID records and for the
numbers you use for memory dialing.
IMPORTANT: You will have approximately 60
seconds to replace the batteries before the
memories stored in the handset are lost. Please
read the instructions before replacing the
batteries and have the batteries ready to be
inserted beforehand.
1. If both the straight and coiled line cords are already
connected, disconnect them from the base unit. Place
the handset off to the side.
2. Use a screwdriver to loosen the two screws on the
battery doors located on the bottom of the base. Once
the screws are fully loosened, (they will not come all
the way out), slide the doors in the direction of the
arrows.
3. Insert 4 AA-size alkaline batteries as shown on the
diagram in the battery compartments. Two batteries will
be inserted for each compartment.
4. Replace the battery compartment doors securely and
tighten the screws, being careful not to strip the
threads.
5. If the cords were previously connected, re-attach the
line cords to the unit and check your memory locations.